• Microphone amplifier for pocket transmitters 

• Amplifier for pocket transmitters without phantom power 

• ATTENTION: there are a limited number of compatible transmitters, including Sennheiser, Wisycom and others, see Downloads. Use with digital transmitters is not intended, as interference may occur. 

Tech Spec –  

 :ca. 4.5 dB less (60%) than the corresponding capsule with CMC 6 

Maximum output voltage :0.9 V (-1dBV) with 20 kΩ load 

0.56 V (-5dBV) with 2 kΩ load 

Low cut filter :- 

Minimum recommended load impedance :5 kΩ 

Output impedance :at 1kHz: 15 Ω 

SCHOEPS RFI Shield :- 

Powering standard / Valid range :4 -10 V 

Current consumption :1 mA Sensitivity

Output :Custom connector, analog, 1 channel, unbalanced 

Connector :assembled according to customer's specification 

Length of the output cable :Standard length: 2m; other lengths possible 

Diameter of the output cable :3 mm 

Length :38 mm 

Diameter :20 mm 

Weight :25 g 

Surface finish :matte gray (g) or custom color