AEA TRP2 Pre-Order

SGD1,299.00

The Original Ribbon Mic Pre with P48

Quantity

 

Terms and Conditions (Please make sure that you have read and understood our terms and conditions prior to purchase at our Terms and conditions of use page located at the bottom.)

 

Delivery Policy

 

Return and Exchange Policy (Goods sold are non-refundable. If there is any manufacturing defects, please check out our exchange, warranty policy to get the goods replaced.)

The AEA TRP2 Ribbon Preamp provides two channels of high-output, high-impedance, and low-noise gain with a rich and natural sound that brings out the full potential of your microphones.

Specifically designed for ribbon microphones, the TRP2 excels at drawing out the warmth and lush sound that ribbons are uniquely known for.

 

The TRP2 is a powerhouse that provides unparalleled high gain with low-noise. With 85db of JFET output, the TRP2 gives you enough juice to record soft sources without ever having to worry about noise.

 

With the TRP2, you will never consider a source too quiet to record with a ribbon mic ever again. Passive ribbons with low output levels require preamps that supply a high level of output. If the preamp you use doesn’t have enough clean gain, the mic signal may seem too soft or noisy which may be apparent when recording quiet acoustic guitars or strings, especially at a distance or with long cable runs. The TRP2 eliminates this concern.

 

The sound and tonality of dynamic microphones like ribbons and moving-coils are directly affected by the impedance of a preamp. The higher the impedance, the better the sound. The RPQ2 boasts an extra high input impedance of 63K Ohms.

 

Preamps with an impedance of under 10k ohms will limit the lows, highs, and transients of your passive microphones. The RPQ2’s high impedance will reveal your microphone’s true nature– a thick low-end, open top-end, and articulate transient response that you will need to hear to believe. Both condensers and active microphones will also benefit from the RPQ2’s impedance.

 

An external switching power supply with a grounded AC plug is used with the TRP2 so hum fields can be kept away from the high-gain electronics. The power supply allows the TRP2 to be used in any country without any modifications made to the unit.

 

The TRP2 is housed in a portable and lightweight half-rack aluminum chassis that allows you to easily take it to remote gigs, other studios, and on the road. AEA manufactures optional racking gear for convenient use in rackmount furniture.

 

A single TRP2 can be easily racked with TRP2 Rack Ears. Rack two TRP2s side by side with a TRP2 Rack Shelf. These assemblies can be securely installed in any standard rack.

 

Passive microphones, coupled with AEA’s range of ribbon-specific preamps, are the key choice for discerning recordists who want total control over their signal path.

 

AEA offers the RPQ2, RPQ500 and TRP2 microphone preamps, all of which provide unmatched clean levels of gain, and a high impedance. All AEA Ribbon Preamps all share the same topology and sound. The differences between each unit come down to extra features and form factor.

 

Two channels with 85dB of sweet and quiet JFET gain

Switchable phantom-power, polarity reverse, and high-pass filter

63k ohm high-impedance circuitry providing better overall transients, frequency response, and higher output sensitivity

Optimized for ribbon mics, condensers, and dynamics

Switching power supply for easy use in any country

1U half-rack with optional hardware for mounting one or two units together

Made in the U.S.A.

Tech Specs

For more information and technical specifications click here

 

 

 

5 Items